• General Construction: Hardwood members are doweled and glued. Additional reinforcement at critical joints is provided with steel brackets or welded tabs and screws.
• Legs: Legs are solid [specify oak or maple], 3” square in section. The bottom of each leg is capped with a 3 1/4” square x 1/4” steel plate, centered on the bottom of the leg and allowing for passage of a leveling glide. 4” rear legs are taller than front legs.
• Chair Back and Seat: Upholstered foam cushion interior. Fabric must be specified. 5” seat cushion rests on a 1” plywood platform that is attached to the side panels and a back support rail. Rear cushion is vertical in profile for the first 4” above the seat and then slopes back for comfort. Upper portion of back cushion extends over the back panel.
• Arms: Chair arms are flat hardwood members. Front of arm rests on an exposed powder coat finished 1 1/2” diameter steel post attached to the top of each front leg. Rear of the arm rests on the top of the rear leg.
• Steel Front Seat Support: The front of the seat is supported by a 1” x 2” rectangular steel tube running between the front legs. Tube is exposed and powder coat finished.
• Side Panels: Side panels are structural frames using 3”W hardwood rails that are doweled into front and rear legs and a panel running between the rails that shows finished matching hardwood veneer face, flush to the inside face of the rails. Outer face of the panel is flush to the outside of the rails and legs may be specified as either hardwood veneer or upholstered cushion. Fabric must be specified if upholstered option is chosen.
• Back Panel: 1-3/16” thick engineered wood panel running between the rear legs and above the arms.

Overall Dimensions
Depth: 31"
Widths: 31", 55.5"
Overall Height: 32"
Seat height: 16"